2PC Beaded Door (Zoom Setup Included)

Finally, a beaded door with the ability to control bead spacing across a panel...

Finally, a beaded door that doesn't crash Mozaik during normal usage.

This door file requires expert setup. Once it is setup properly it is very easy to use. The doors are sent to the CNC from the Order tab in Mozaik.

VERSION 14 ONLY

-----------------------------------------

The intended purpose is for 2 piece construction. Common configurations would be:

- 1/4" Beaded Frame with 1/4" Beaded Panel

- 3/8" Beaded Frame with 1/4" Beaded Panel

- 1" Square Frame with 1/4 or 3/8" Beaded Panel

------------------------------------------

Required Materials: Depending on the combination of bead sizes, 3/4-1" Frame and 3/8" to 5/8" MDF could be required. These thickness requirements are pretty flexible.

------------------------------------------

Required Tooling: 

1/8" Roundover

3/16" Roundover

1/8" Downshear (long cutting edge may be required)

3/8" or 7/16" or 1/2"

40MM PCD Pocketing Bit for clearing (Or other pocketing bit)

------------------------------------------

The setup will cover ONE of these combinations (we can record the session so you can make your own later),

Download will be delivered just before the training. See required tool list below.

This is a very new product: Instructional videos will be available by the end of July. If you cannot wait until then for self-seteup. Grab the product and some training.

------------------------------------------