To change the toe recess in the PAC Mozaik Closet Library, open Job Parms then the Toe category and edit Toe Recess. For a flush toe set it to about 0.1 mm. If going flush removes the 5 mm fastener holes, open the Fastener category, open the Joint Fastener, and enable Variable Toe to bring the holes back so you can place the toe anywhere.
How do you change the toe recess?
On the left in Job Parms, open the Toe category and change the Toe Recess. To go flush, enter something like 0.1 mm.
Why is it set where it is by default?
So the toekick connects into the front ledger board. Many modern closets push the toe forward or flush instead. It is your call.
Going flush removes the fastener holes. Here is the fix
At flush you lose the 5 mm holes for fasteners. Open the Fastener category, then the open Joint Fastener, and enable Variable Toe. That adds the two holes back, so you can put the toe wherever you want.
Watch the walkthrough
Get it done-for-you
You can change the toe recess by hand using the steps above. The PAC Mozaik Closet Library comes with the toe, variable-toe fasteners, and recess logic pre-built, so it just works in Mozaik.
Full disclosure: Phill Anton Consulting makes this product.
FAQ
How do you change the toe recess in the PAC Closet Library?
In Job Parms (left side) then the Toe category, change the Toe Recess value. For flush, set it to about 0.1mm.
Why is the default toe recess set where it is?
So the toekick connects into the front ledger board. Move it forward or flush if you prefer a more modern look.
I set it flush and lost my fastener holes. How do I get them back?
Open the Fastener category, then the open Joint Fastener, and enable Variable Toe. That restores the two 5mm fastener holes so you can place the toe anywhere.