To change toe height in the PAC Mozaik Closet Library, set the ToeH parameter in 32 mm increments. The default is 96.1. Lower it (for example to 64.1) and there is only room for one cam, so add a support bracket behind the toekick when there is no carpet. There is no undo: to restore the default, type 96.1 back into ToeH.
How do you adjust toe height?
Change the ToeH parameter. The rule is to go down in 32 mm increments (you can go less, but it is not advised). The default is 96.1.
What is the trade-off when you lower it?
Drop it (for example to 64.1) and in 3D you will see there is only room for one cam, not two. If there is no carpet, add a support bracket behind the toekick so the toe does not scoot in.
How do you undo it?
There is no Ctrl+Z. To restore the default, type 96.1 back into ToeH.
Watch the walkthrough
Get it done-for-you
You can adjust ToeH by hand using the steps above. If you build closets regularly, the PAC Mozaik Closet Library ships with toe height and the cam logic already set up, drag-and-drop in Mozaik, so you can skip the setup.
Full disclosure: Phill Anton Consulting makes this product.
FAQ
How do you change toe height in the PAC Closet Library?
Set the ToeH parameter, going down in 32mm increments. The default is 96.1; to restore it, re-type 96.1 (there is no undo).
What happens if you lower the toe height?
At a lower height (e.g. 64.1) there is not room for a second cam, so you get one cam. Add a support bracket behind the toekick if needed.